ZyAIR G-5100Outdoor 802.11g Business Access Point/Bridge/RepeaterQuick Start GuideVersion 3.502/2005
ZyAIR G-5100104 Hardware InstallationIn general, the best location for the access point is at the center of your intended wireless coverage area. It i
ZyAIR G-510011The grounding system must comply with the National Electrical Code and safety standards that apply in your country. Always check with a
ZyAIR G-5100122 Align the top two holes in the back of the ZyAIR with the holes in the first mast-mounting bracket. Insert the two screws into the sid
ZyAIR G-510013For omni-directional antennas mounted on a table, desk, and so on, point the antenna up. For omni-directional antennas mounted on a wall
ZyAIR G-5100145.1 Set Up Your Computer’s IP AddressThis section shows you how to assign your computer a static IP address in the 192.168.5.2 to 192.16
ZyAIR G-51002OverviewThis Quick Start Guide shows how to set up and configure the ZyAIR to allow wireless clients to access your wired network. See yo
ZyAIR G-510032 Hardware ConnectionsAccessories Specification/Description QuantityInline Power Injector (PoE) Input 100 ~ 240VAC 50/60Hz, Output 800mA
ZyAIR G-510041 Use the included spanner (installation tool) to connect the ground cable to the ZyAIR’s frame ground (as shown). Connect the other end
ZyAIR G-510056 Optional: Use the MIL-C-5015 style RS-232 console cable to connect the special serial port to a computer running a terminal emulation p
ZyAIR G-510063 Initial ConfigurationUse Internet Explorer 6.0 and later or Netscape Navigator 7.0 and later versions with JavaScript enabled. Note: Ev
ZyAIR G-510075 Click WIZARD SETUP in the MAIN MENU screen.3.1 Wizard SetupUse the setup wizard to configure your ZyAIR for wireless stations to access
ZyAIR G-51008Your settings are not saved when you click Back.1 This screen is optional. You can just click Next.2 Use the second wizard screen to set
ZyAIR G-510093 Fill in the fields in the last wizard configuration screen.7 Change the wireless parameter settings in the wireless stations to match t
Comments to this Manuals