ZyXEL Communications PLA-4xx User's Guide download pdf (Page 36)

Appendix A Product Specifications

PLA-400/402 Series User’s Guide

Wall-mounting Instructions

Complete the following steps to hang your PLA-400/402 on a wall.

" See Table 7 on page 35 for the size of screws to use and how far apart to place

them.

1 Select a high position on a sturdy wall that is free of obstructions.

2 Drill two holes for the screws. The distance between the centers of the holes is listed in

the product specifications appendix.

1 Be careful to avoid damaging pipes or cables located inside the wall when

drilling holes for the screws.

3 Do not insert the screws all the way into the wall. Leave a small gap of about 0.5 cm

between the heads of the screws and the wall.

4 Make sure the screws are snugly fastened to the wall. They need to hold the weight of

the PLA-400/402 with the connection cables.

5 Align the holes on the back of the PLA-400/402 with the screws on the wall. Hang the

PLA-400/402 on the screws.

Network Password Change the power line network password to only allow the ethernet

adapters you specify to join your network.

Firmware Upgrade Download new firmware (when available) from the ZyXEL web site and

use the configuration utility to install it.

Note: Only upload firmware for your specific model!

Table 9 Performance

FEATURE DESCRIPTION

Throughput over PHYsical Transport

Medium (PHY)

Supports up to 200 Mbps in half duplex mode

Throughput over UDP Supports up to 150 Mbps over in-house power/coaxial

lines (LAN port limits to 100 Mbps)

Number of Devices in one power line

network

Supports up to 64 devices

Table 8 Firmware Specifications

FEATURE DESCRIPTION

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

No comments

ZyXEL Communications PLA-4xx User's Guide Page 36