ZyXEL Communications omni.net User's Guide download pdf (Page 52)

Omni.Net Lite User’s Guide

51 Chapter 2 Using the Utility

Figure 18 Analog Port: Supplementary Service

2.12.4.4 Call Transfer

You can transfer a call to a local phone (connected to the TA) or a remote phone (not

connected to the TA) through an ISDN line.

2.12.4.4.1 Call Transfer between Two Analog Ports

To transfer incoming calls (after you answer this call) to a local phone, follow these steps:

1 Press the flash key to put the caller on hold.

2 When you hear the dial tone, dial “1#” to operate the Intercom.

3 After you hear the ring signal or the second party answer it, press the flash key, then “4”.

4 Hang up the phone.

2.12.4.4.2 Call Transfer to a Remote Phone

To transfer incoming calls (after you answer this call) to a remote phone, follow these steps:

1 Press the flash key to put the caller on hold.

2 When you hear the dial tone, simply dial the number you want, to transfer the first call.

3 After you hear the ring signal or the second party answer it, press the flash key, then “4”.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 83 84

No comments

ZyXEL Communications omni.net User's Guide Page 52