ZyXEL Communications omni.net User's Guide Page 57

  • Download
  • Add to my manuals
  • Print
  • Page
    / 84
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 56
Omni.Net Lite User’s Guide
Chapter 3 Using AT Commands 56
No parity, 8 data bits, 1 stop bit, flow control set to hardware
6 The DTR LED is on. If it is off, check the HyperTerminal settings and your cable
connections.
7 Type in AT and press
[ENTER]. The terminal will response OK as shown below. You can
now use the commands with an “AT” or “at” prefix to configure the TA. Refer to Chapter
5 on page 72 for detailed information on AT command sets.
Page view 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 83 84

Comments to this Manuals

No comments