ZyXEL Communications P-660R-Tx v2 Series User's Guide Page 36

  • Download
  • Add to my manuals
  • Print
  • Page
    / 175
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 35
P-660R-Tx v2 Series User’s Guide
Chapter 2 Introducing the Web Configurator 37
2.2.1 Using the Reset Button
1 Make sure the PWR/SYS LED is on (not blinking).
2 Press the RESET button for ten seconds or until the PWR/SYS LED begins to blink and
then release it. When the PWR/SYS LED begins to blink, the defaults have been restored
and the ZyXEL Device restarts.
2.3 Navigating the ZyXEL Device Web Configurator
The following summarizes how to navigate the web configurator from the SITE MAP screen.
Click Wizard Setup to begin a series of screens to configure your ZyXEL Device for the
first time.
Click a link under Advanced Setup to configure advanced ZyXEL Device features.
Click a link under Maintenance to see ZyXEL Device performance statistics, upload
firmware and back up, restore or upload a configuration file.
Click SITE MAP to go to the Site Map screen.
Click Logout in the navigation panel when you have finished a ZyXEL Device
management session.
Figure 5 Web Configurator: Site Map Screen
Click the icon (located in the top right corner of most screens) to view embedded help.
Table 3 Web Configurator Screens Summary
LINK SUB-LINK FUNCTION
Wizard Setup Connection
Setup
Use these screens for initial configuration including general
setup, ISP parameters for Internet Access and WAN IP/DNS
Server/MAC address assignment.
Advanced Setup
Password Use this screen to change your password.
LAN Use this screen to configure LAN DHCP and TCP/IP settings.
Page view 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 174 175

Comments to this Manuals

No comments